4 mounting procedures, Figure 2-2 mounting procedures – EOTech Mini Red Dot Sight (MRDS) User Manual

Page 17

Text mode
Original mode

2-3

2.4 MOUNTING PROCEDURES
Two 8mm screws are used to secure the MRDS to a DOCTER® sight mount as shown in
Figure 2-2. Use the provided 10mm screws if also installing the Protective Shield.

a. Slide the MRDS in the Protective Shield (if being installed).

b. Place the MRDS (and Protective Shield) onto the mounting studs of the DOCTER®

sight mounting plate.

c. With an M2 hex head wrench, secure the MRDS to the DOCTER® sight mounting

plate by installing and then tightening the appropriate mounting screws.

Figure 2-2 Mounting Procedures

Mounting Studs