Cyron Lighting HTW1010 RGB - Manual (Page 7)

mode. Inversely, it can be set to never turn on automatically when the
power is restored, also referred to as Auto Off.
Use Auto On setting and connect the controller to a timer.
Every time the timer comes on the lights will turn on
automatically. Same is true if controller is plugged into an
outlet that is controlled by a wall switch. Lights can be turned
on by the wall switch
To set the controller to Auto On:
Turn off the lights using the power off button. On the remote press
buttons "7, 7, 1". Lights will flash to confirm. Disconnect power and
reconnect to test. Lights should turn on automatically.
To set the controller to Auto Off:
Turn off the lights using the power off button. On the remote press
buttons "7, 7, 2". Lights will flash to confirm. Disconnect power and
reconnect to test. Lights should remain off.