Cyron Lighting HTW1010 RGB - Manual (Page 3)

Keep the controller and wires away from extreme heat, liquids, and moving
objects.
Low voltage wires can be routed through walls and cabinets as long as proper
care is taken to avoid damages.
DO NOT modify internal components. Tampering with components and wiring
may cause severe damage to your system and will void factory warranty.
The CONTROLLER operates on 100% regulated 12 or 24VDC power. The
size (wattage) of the power supply depends on the number of lights. Table
below will help in determining the maximum number of lights and the power
supply ratings to be used.
CYRON
Series/Size Watts per
one
lightbar
Model no.
available (Qty) Max Qty
with
HTW1010
HTP (Pro) / 9”
1.20
HTPB9 (2x9”)
160
HTP (Pro) / 15”
2.20
HTPB15 (2x15”)
90
HTP (Pro) / 24”
4.00
HTPB24 (2x24”)
50
Ribbon LED / HTPR 2.20 / ft HTPR-RL 90 feet
Ribbon LED / HTPRX 2.20 / ft HTPRX-RL 90 feet
HTPRZ-2H24 4.40 / ft HTPRZ-2H24RL 90 feet
There are two methods of connecting lights to the controller:
1. PLUG-n-PLAY lightbar connection
CYRON Media Highlighter multicolor lights are supplied with pre-installed
connectors which can be directly plugged into controller ports. Pay attention to
the polarity of the plugs. Do not use excessive force. The order in which they
get connected does not matter. You can plug as few as one or as many as
twelve. Use wire zip ties or other means of wire management to secure the
wires.
CYRON hub extender (part# HTH61) provides 5 more outlets. If your system
is using too many hub extenders, then you should be thinking about hardwiring
the lights instead.
2. HARDWIRING Connecting more than 12 CYRON lightbars
You may choose this option if :
a) You are connecting far more than 12 lightbars
b) Lightbar wires are too short for your project
c) Using CYRON Ribbon lights
d) You are a contractor and are familiar with wiring practices
e) Intending to utilize more than 100 watts of power