Cyron Lighting HTW1010 RGB - Manual (Page 5)

Turn-off timer. There are 5 timers of 1, 2, 3, 4 and 5 hours.
Each time the button is pressed the lights will flash according
to the number of hours.
>First press; lights flash once; system turns off in 1 hour.
>Second press; lights flash twice; system turns off in 2 hours.
>Third press; lights flash three times; system turns off in 3
hours.
Same applies for up to 5 hours. Press again to go back to 1
hour.
Red, Green and Blue COLOR DIALS allow adjustment of
each color from zero brightness to full brightness in 50 steps.
The UP arrows increase and down arrows decrease the
brightness level of each particular color. By combining
different levels of each color more than 117,000 color
combinations will be possible. Use COLOR DIALS to match
décor colors, create varies tones of white light, or reduce the
brightness of colors. See Memory function below to save a
custom color.
COLOR DIALS only operate on memorized colors and
PAUSED colors.
You cannot press-and-hold to rapidly change thru the
50 steps. Buttons must be pressed once for each step.
MUSIC MODE. The lights will change colors and interact
with sound. There are two ways to take advantage of this
feature.
a. Built in Microphone: A microphone is placed
inside the controller which can pick up ambient
sound. If the ambient sound is loud enough the lights
will start to interact. Placement of the controller box
and the amplitude of sound plays a big role in how
well the Music Light will work.
b. Audio Input: Alternatively, you may plug the
headphone output of a stereo system or personal
music player to the MIC input. A cord has been
provided. Depending on your audio system you may
need a different type of connection. The built-in
microphone is disable once the cord has been
plugged into the controller.