Ashland I-130XL2 Ver 3-2007 - Manual (Page 37)

Machine cuts unevenly.
1. Cutting edges worn unevenly.
a) Replace cutting edges.
2. Improperly inflated tires.
a) Check air pressure in tires.
Apron closes slowly
or
Apron and push-off are not working well together.
1. Sequence valve needs adjusting.
a) Remove acorn nut from end of sequence valve with a ½” wrench. Turn adjustment
screw, using a 4mm hex wrench, clockwise until front apron rises before the push-off ad-
vances while the earthmover is empty. Turn the adjustment screw an additional ¼ turn
clockwise, then replace the acorn nut and tighten.
b) Torque check valve assembly and int. pilot plug to 25 ft-lbs maximum.
CAUTION! Overtightening check valve assembly and int. pilot plug will cause
internal damage to the sequence valve.
Note: Check valve assembly may leak slightly when torqued to 25 ft-lbs.