Ashland I-130XL2 Ver 3-2007 - Manual (Page 15)

KEY NO. PART NO. DESCRIPTION
1. A123365-05 Cylinder Barrel
2. A300H06 O-Ring: 4” OD x 3/16”
3. A300H11 Head Gland
4. A300H12 Retainer Ring
5. A22H15 O-Ring: 1-1/2” ID x 1/8”
6. A22H15A Backup Washer: 1-1/2”
7. A300H13 Gland Cap
8. A22H18 Capscrew: 1/4” NC x 1”
9. A22H17 Wiper Seal: 1-1/2” ID
10. A123362 Pin, 1-1/2” with slot for keeper bushing
11. 8602 Pin, Cotter1/4” x 2” Zinc
12. A123351 Bushing, retaining flange, 9/16”ID x 3/4”OD, 3/4” L
13. A123365-03 Rod, S/N 20497 + Welded Eye with 1-1/2” Hole
** If your unit has thread block type rod end see following page **
14. A45H05 Piston Gasket: 1”
15. A300H07 Piston: 4” Dia.
16. A300H05 Backup Washer: 4” OD
17. A300H04 Cast Iron Ring: 4” OD
18. A300H03 Piston Nut, 1” NF
19. A123363 Pin: 1-1/2” square head
20 AFB-00015 HHCS 1/2”NC x 1-1/2” Gr. 8
A300H14B Packing Kit, Containing:
(1) A300H04 (1) A22H15
(2) A300H05 (1) A22H15A
(2) A300H06 (1) A22H17
(1) A45H05
IMPORTANT
Some units prior to this serial num-
ber were upgraded to a H.D. Apron
Cylinder by the customer Please
determine if the cylinder pins are
1-1/2”diameter. If pins are 1” or
1-1/4” and is inserted into a thread
block ear on the rod end please
refer to page next page
MODEL I-155 TS
LEFT & RIGHT SIDE APRON CYLINDER 4 X 13
PART NO. A123365