0 inlet/outlet valve replacement – AirSep MN155-1 User Manual
Page 11
7
Disconnect from any oxygen source before attempting any service or
repair.
2.0 Inlet/Outlet
Valve
Replacement
2.1
With a Phillips head #2 screwdriver, remove the three screws in the back of the
device. Pull the bottom of the back cover out then rotate up and away to remove the
cover.
Figure 9
2.2
Using two wrenches, hold the inner nut in place with one wrench (7/16 inch) and
unscrew the outer nut with the other wrench (5/8 inch).
Figure 10
Remove 3 screws,
then the rear cover
See also other documents in the category AirSep Health and hygiene:
- MN170-1 D (40 pages)
- MN172-1 (502 pages)
- MN189-1 (12 pages)
- MN123-1 F (45 pages)
- MN131-1 B (556 pages)
- MN166-1 B (40 pages)
- MN167-1 (520 pages)
- MN168-1 (3 pages)
- MN169-1 (40 pages)
- MN092-1 D (13 pages)
- MN104-1 D (40 pages)
- MN112-1 (208 pages)
- MN119-1 D (4 pages)
- MN120-1 (44 pages)
- MN078-1 F (42 pages)
- MN084-1 D (137 pages)
- MN139-1 (144 pages)
- MN164-1 (30 pages)
- MN152-1 (18 pages)
- MN136-1 H (27 pages)
- MN137-1 D (190 pages)
- MN156-1 B (18 pages)
- MN157-1 B (332 pages)
- MN165-1 G (28 pages)
- MN175-1 (2 pages)
- 15062781 (16 pages)
- 4111-7 (95 pages)
- 20626704 (24 pages)
- 20626704-C1 (154 pages)
- ML-CONC0056 (2 pages)
- MN028-1 (1 page)
- MN171-1 (23 pages)
- MN083-1 (1 page)
- MN126-1 C (69 pages)
- MN179-1 B (62 pages)
- MN110-1 (30 pages)
- MN105-1 C (52 pages)
- MN118-1 B (40 pages)
- MN134-1 B (40 pages)
- MN151-1 (1 page)
- MN188-1 (1 page)
- MN188-2 (2 pages)
- MN138-1 H (46 pages)
- MN178-1 (1 page)