Asus A7N266-C - Manual (Page 18)

18 ASUS A7N266-C User’s Manual
3. HARDWARE SETUP
3. H/W SETUP
Motherboard Settings
A7N266-C
0 1 0 1 0 1
®
A7N266-C Jumper Mode Setting
JEN
Enable
(Default)
2 3
Disable
1 2
2) Jumperfree Setting (JEN)
Normally, all changes to frequency settings can be made through BIOS
immediately upon starting up the computer. Therefore, the default setting for
this jumper, [2-3] enables easy BIOS adjustments. If the BSEL jumpers are
used, it is necessary to set this JEN jumper to [1-2].
A7N266-C
0 1 0 1 0 1
®
A7N266-C Onboard LED
PLED
WARNING
ON
Incorrect
AGP Card
OFF
Correct
AGP Card
ON
Standby
Power
OFF
Powered
Off
1) Onboard System Indicators (LED - Light Emitting Diodes)
The GREEN onboard LED indicates that the system power is okay. This light
also lights when the PC is in suspend or soft-off mode. The RED onboard warning
LED lights up only if the wrong type of AGP card is connected to the board:
(See AGP Pro, p. 28)