beautypg.com

P5kpl-am front panel audio connector, Aafp, P5kpl-am intrusion connector chassis – Asus P5KPL-AM/PS User Manual

Page 36: 26 chapter 1: product introduction

background image

1-26

Chapter 1: Product introduction

10. Front panel audio connector (10-1 pin AAFP)

This connector is for a chassis-mounted front panel audio I/O module that supports

either HD Audio or legacy AC`97 audio standard. Connect one end of the front panel

audio I/O module cable to this connector.

P

5

K

P

L

-A

M

P5KPL-AM Front Panel Audio Connector

HP_HD

MIC2_L

HP_R

HP

_L

MIC2_J

D

Jack_Sens

e

MIC2_R

PRESENSE#

AGND

AAFP

Legacy AC’97-compliant

pin definition

NC

MIC2_L

Line out_R

Line out_L

NC

NC

MIC2_R

NC

AGND

Azalia-compliant

pin definition

• We recommend that you connect a high-definition front panel audio module to this

connector to avail of the motherboard’s high-definition audio capability.

• If you want to connect a high-definition front panel audio module to this connector, set

the Front Panel Support Type item in the BIOS setup to [HD Audio]. If you want to

connect an AC'97 front panel audio module to this connector, set the item to [AC97]. By

default, this connector is set to [HD Audio]. See section 2.4.4 Chipset for details.

9.

Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect

one end of the chassis intrusion sensor or switch cable to this connector. The chassis

intrusion sensor or switch sends a high-level signal to this connector when a chassis

component is removed or replaced. The signal is then generated as a chassis intrusion

event.

By default , the pin labeled “Chassis Signal” and “ Ground” are shorted with a jumper

cap. Remove the jumper caps only when you intend to use the chassis intrusion

detection feature.

P

5

K

P

L

-A

M

P5KPL-AM Intrusion Connector

CHASSIS

+5VSB_MB

Chassis Signal GN

D

(Default)

This manual is related to the following products: