Asus USB-N10 - Manual (Page 41)

ASUS USB-N10 41
Troubleshooting
The following troubleshooting guides provide answers to some of the more
common problems, which you may encounter while installing or using network
adapter products. If you encounter difficulties that are not mentioned in this section,
please contact the Wireless LAN Technical Support.
Verify if the network adapter is installed correctly.
When the network adapter setup is complete, you can verify if the driver has been
setup properly. Right click My Computer, select Properties, and click the Device
Manager tab. Then double-click the Network adapters icon. You should see
“ 802.11g Network Adapter” with an icon of an expansion adapter. There should
not be a “!” or “?” (problem) or “x” (disabled) symbol over this icon.
There is a yellow exclamation mark or a yellow question mark in Device Manager
in front of my network adapter.
To resolve the problem, you should update/reinstall the network adapter driver. In
“Device Manager”, right click 802.11g Network Adapter, select Properties, and
select Driver tab. Click on Update Driver button, then follow the “Update Device
Driver Wizard” to complete the driver installation.
Cannot connect to any access points
Follow the procedure below to configure your network adapter.
a. Verify that the “Network Type” is in “Infrastructure” mode.
b. Verify that the “SSID” of your network adapter is set to the same “SSID” of an
access point.
c. Verify that the “Encryption” type is the same as that of an access point. If you
enabled “WEP” encryption, you must also set the same WEP Keys on both
sides.
Cannot connect to a Station (network adapter)
Follow the procedure below to configure your network adapter.
a. Verify that the “Network Type” is in “Ad Hoc” mode.
Chapter 5
Troubleshooting