GE 45146 GE Choice Alert Wireless Keypad User Manual

Page 9

Step 1. Press and release Green button. Enter Current

Master code. Press and release the Green button. The

LED will light.
Note: You have approx 30 seconds to make a selection

at each step, or the LED will flash 3 times and turn off.

If it does, you’ll have to start over.
Step 2. Enter a number (2, or 3) for the code you

would like to erase (2= User 2 code, 3 = User 3 code).

Press and release the Green button three times.
The LED will flash 5 times and turn off indicating the

code for that number has been erased.

Placement of the Wireless Keypad.
The Wireless Keypad is designed to be mounted inside

onto a wall, or it can lay on a flat surface (such as a

night stand). If mounting to a wall, use the double-

sided tape strips or the screws/wall anchors (both

included).
Note (1): Do not mount in an exterior location; the

Wireless Keypad is not weather resistant.
Note (2): The Wireless Keypad can transmit up to

150ft. However like all wireless devices, this distance

is subject to conditions of the home. The number of

walls and appliances between the Wireless Keypad

and the location of the Control Center can reduce

the signal transmission distance. When selecting a

placement, test the Wireless Keypad at the location

before mounting. Using a signal repeater can extend

the transmission distance.