GE 45146 GE Choice Alert Wireless Keypad User Manual
Page 6
6
7
1 2 3 4
Arm
Zone
Armed Power
1
2
3
4
Alert
Chime
Off
Mute
Learn
Input DC 12V
-
+
Step 1
Press and hold
the Learn button
for three seconds
Step 3
To activate the keypad
press the panic button
on the unit.
Step 2
Press and release the
Device number
Activating the Battery
The Wireless Keypad is packaged with the battery
installed, but not activated. To activate the battery,
remove the yellow battery isolation strip on the side
edge; pull to remove. Once the strip is removed, the
Wireless Keypad will be active.
Assigning a Wireless Keypad to a Device Location
The Control Center is designed to store up to four
remote transmitters, such as the Wireless Keypad. In
order to ensure that the Wireless Keypad will operate
only with your Control Center, it must be assigned to
one of the four device locations on the Control Center.
Step 1. Press and hold the Learn button on the Control
Center. You will hear a short beep, followed shortly by a
long continuous beep. Release the Learn button.
Step 2. On the Control Center, press and release one of
the device numbers (1,2,3 or 4) that you want to assign
the Wireless Keypad. The LED for that device number
will begin to flash.