AT&T Trimline 265 - Manual (Page 32)

29
CALLER ID OPERATION
Setting Options
Review Call Log
The screen displays call information
for about 10 seconds after it has been
received.
This function can be accessed
regardless of whether the handset is
lifted or not.
1. Press T or S to activate the call
list and display the latest caller ID
entry.
2. Press T once to show the previous
caller ID entry. Press T repeatedly
to scroll through the call list in
reverse chronological order (from
the latest entry to the earliest
entry), or
3. Press S twice when the screen is in
idle mode and it will show -END
OF LIST-. Then press S
repeatedly to scroll through the call
list in chronological order (from the
earliest entry to the latest entry).
4. At the end of the call list, the screen
displays -END OF LIST- and
begins again.
Display Dial
Dial a displayed
telephone number when
reviewing calls in call log.
1. Press S or T until the
screen displays the
destination number.
2. Press DISPLAY
DIAL to make the
call, LIFT
RECEIVER will be
displayed.
3. Lift the handset, the
number shall be dialed
out or press the
CLEAR key to cancel
this operation.
NOTE:
The display dial feature
cannot be used to dial
PRIVATE or
UNKNOWN calls.
Call Log
A number (from 01 to 80) is assigned
numerically in ascending order for
each incoming call. The most recent
call will have the highest number.
Only the newest entry from a
telephone number will be saved.
When the memory is full, the oldest
call information is replaced by the
new incoming call information.