GE 45613 GE Z-Wave 3-Way Dimmer Kit with Terminals - Manual (Page 16)

pressing and holding the rocker until the light intensity is at the
minimum setting does not turn the power OFF; you must still tap
(press & release) the bottom of the rocker to turn the power OFF.
• When OFF, pressing and holding the bottom of the rocker will
cause the lighting to go to the minimum dim level.
Program your Light Switch (Include or exclude the switch to/
from the Z-Wave home control network.)
• Refer to the instructions for your primary controller to access
the network setup function and include or exclude devices.
• When prompted by your primary controller, tap the top or
bottom of the rocker.
• The primary controller should indicate that the action
was successful. If the controller indicates the action was
unsuccessful, please repeat the procedure.
• Once the switch is part of the network, the same basic
procedure is used to add the switch to groups & scenes or
change advanced functions. Refer to the primary controller’s
instructions for details.
Note: After a power failure, the 45612 dimmer switch will
default to OFF.
LED Indicator
The LED will be lit when the connected lighting is OFF.
This is the factory default setting and can be changed if your
primary controller supports the node configuration function (see
Advanced Operation below)