GE 51207 GE Wireless Motion Sensor Alarm with Keychain Remote User Manual
Page 9
10
Arming the Alarm
Point the remote control at the front of
the alarm and press the ARM button.
The alarm will sound a tone and the
red indicator light will flash. There will
be a second exit delay before the
unit is armed. The delay allows time
for you to leave the protected area
without triggering the alarm.
When motion is detected, the alarm
unit will sound a short tone and a red
light will flash. The alarm will activate
in 30 seconds. The siren will sound
for 30 seconds (unless disarmed by
the remote) and then turn off. In 1
seconds the alarm will check for
motion. If motion is detected, the siren
will sound again. The cycle will repeat
until the unit is disarmed with the
remote.
1.
2.