Care and cleaning of the vent hood, Caution – GE PV977NSS User Manual
Page 6

6
49-80550-2
Care and cleaning of the vent hood.
Be sure electrical power is off and all surfaces are cool before cleaning or servicing any part
of the vent hood.
Light Bulbs
Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface, use
warm sudsy water or a stainless steel cleaner
or polish. Always wipe the surface in the
direction of the grain. Follow the cleaner
instructions for cleaning the stainless steel
surface.
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please call
our toll-free number:
National Parts Center
800.626.2002
GEApplianceParts.com
Stainless Steel Surfaces
CAUTION:
Allow bulbs to cool before touching
.
To change the light bulbs:
1. Remove the lamp lens cover by inserting
a small flat blade screwdriver into each of
the three slots and gently prying it free.
NOTE: Do not remove the outer trim ring
(lamp assembly).
2. Wear gloves. Do not touch the bulb with
your bare fingers. Skin oils can cause
early lamp failure.
3. Grasp the bulb and pull it straight out.
4. Replace with the same wattage. Early bulb
failure and damage to or failure of the
transformer may occur if wattage
is too high.
These 12-volt, 20-watt halogen bulbs
with a G4 base are available at specialty
lighting stores and home building centers.
To order replacement bulb no.
WB01X10239, contact the GE National
Parts Center at 1.800.626.2002 or purchase
from your local retailer.
5. Replace lamp lens cover by inserting
the three retaining tabs into the three slots
and pressing firmly in place.
Use a small flat blade screwdriver
to remove the lamp lens cover.
Outer trim ring
(lamp assembly)
Do not remove
Bulb
Removable inner
lamp lens cover
NOTE: Make sure the tabs are inserted into the slots.
Tab