GE PV977NSS - Manual (Page 25)

49-80550-2
25
Installation Instructions
STEP 11 INSTALL DUCT COVERS
IMPORTANT: Two people are required to install
the duct covers.
NOTE: If you are installing this hood for recirculating
operation, place the duct covers onto the hood with
the venting slots at the top. If the hood is vented to
the outside, the holes should be positioned on the
bottom.
• Remove the protective film from all duct covers.
• Place one upper duct cover over the rear of the
support assembly. The tabs on the edges of the
duct cover will slide into a notch on the duct cover
support. When all 6 tabs on the duct cover are in the
notches on both of the duct cover supports, slide the
duct cover up so it sits on the duct cover support
spring clip.
Left duct
cover
Duct cover
support spring
clip
STEP 11 INSTALL DUCT COVERS (cont.)
• Place a duct cover clip onto the bottom of the
rear lower duct cover locking the clip into place.
Repeat on the other side.
• Lower the duct cover into the recess on the hood.
• Place the front lower duct cover into the recess of
the hood locking it onto the duct cover clip on the
rear cover.
• Place a duct cover clip on each side where the
front and rear duct covers meet. This will hold the
rear and front covers together.
Duct cover clip
• Using screws provided, secure the lower duct
covers to the hood assembly from the underside
of the hood.