GE JAS02SNSS - Manual (Page 36)

Installation Instructions
INSTALL THE RANGE
13 FINAL INSTALLATION CHECKLIST
• Check to make sure the circuit breaker is closed
(RESET) or the circuit fuses are replaced.
• Be sure power is in service to the building.
• Check to be sure that all packing materials and tape
have been removed. This will include tape on metal
panel under control knobs (if applicable), adhesive
tape, wire ties, cardboard and protective plastic.
Failure to remove these materials could result in
damage to the appliance once the appliance has
been turned on and surfaces have heated.
• Check to make sure that the door and drawer
are parallel to each other and that both operate
smoothly. If they do not, see the Owner’s Manual
for proper replacement.
• Check to make sure that the rear range arm is
fully inserted into the Anti-Tip bracket and that the
bracket is securely installed.
14 OPERATION CHECKLIST
• Turn on one of the surface units to observe that the
element glows within 60 seconds. Turn the unit off
when glow is detected. If the glow is not detected
within the time limit, recheck the range wiring
connections. If change is required, retest again. If no
change is required, have building wiring checked for
proper connections and voltage.
• Check to make sure the Clock (on models so equipped)
display is energized. If a series of horizontal red lines
appear in the display, disconnect power immediately.
Recheck the range wiring connections. If change is
made to connections, retest again. If no change is
required, have building wiring checked for proper
connections and voltage. If is recommended that the
cook be changed if the red line appear.
• Be sure all range controls are in the OFF position
before leaving the range.
12 REPLACE THE STORAGE DRAWER
Place the drawer rail on the guides.
Push the drawer in until it stops.
Lift the front of the drawer and push in until the stops
clear the guides.
Lower the front of the drawer and push in until it
closes.
36
Stop