HP ProLiant ML310 G5 Server - Manual (Page 34)

Hardware options installation 34
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To install the component:
1. Power down the server (on page 17 ).
2. Remove the bezel (on page 18 ).
3. Remove the access panel (on page 19 ).
4. Remove the applicable media bay blank (" Remove a media bay blank " on page 20 ).
5. Install the tape drive.
6. Connect the USB tape drive cable to the USB tape drive cable connector on the system board.
7. Remove the applicable bezel blank from the bezel (" Remove a bezel blank " on page 20 ).
8. Install the access panel (on page 19 ).
9. Install the bezel.