HP Mini 5102 - Manual (Page 121)

Select To do this
Device configurations ● Enable Fn Key Switch
● Enable/disable USB legacy support. When enabled, USB
legacy support allows the following:
◦ Use of a USB keyboard in Computer Setup even
when your operating system is not running.
◦ Startup from bootable USB devices, including a hard
drive, diskette drive, or optical drive connected by a
USB port to the computer.
● Enable/disable fan always on while connected to an AC
outlet.
● Enable/disable Data Execution Prevention (select
models only). When enabled, the processor can disable
some virus code execution, which helps to improve
computer security.
● Enable/disable LAN power saving mode.
● Set the SATA (Serial Advanced Technology Attachment)
device mode. The following options are available:
◦ AHCI (Advanced Host Controller Interface)
◦ IDE (Integrated Drive Electronics)
● Enable/disable HP QuickLook.
● Enable/disable HP QuickLook preboot authentication on
HP QuickLook boot.
● Enable/disable HP QuickWeb.
● Enable/disable HP QuickWeb: Write Protect (disabled by
default).
● Enable/disable Intel® HT Technology.
● Enable/disable Wake on USB (disabled by default).
● Enable/disable Numlock state at boot: Off /On (disabled
by default).
Built-in device options ● Enable/disable the wireless button state.
● Enable/disable embedded WLAN device radio.
● Enable/disable Network Interface Controller (NIC).
● Enable/disable LAN/WLAN Switching (disabled by
default).
● Set the wake on LAN state.
◦ Disabled
◦ Boot to Network
◦ Follow Boot Order
● Enable/disable the integrated camera (webcam).
Computer Setup menus 111