HP ProLiant DL580 G4 Server User Manual
Hp proliant dl580 generation 4 server user guide
Table of contents
Document Outline
- HP ProLiant DL580 Generation 4 Server User Guide
- Notice
- Contents
- Server component identification
- Front panel components
- Front panel LEDs and buttons
- Memory board components and LEDs
- Processor module LEDs
- Rear panel components
- Rear panel LEDs and buttons
- Power supply LEDs
- System board components
- Systems Insight Display LEDs
- DIMM slot locations
- SATA or SAS drive numbers
- SATA or SAS hard drive LEDs
- SAS and SATA hard drive LED combinations
- Fan locations
- Hot-plug fan LEDs
- Server operations
- Server setup
- Optional installation services
- Rack planning resources
- Optimum environment
- Rack warnings and cautions
- Identifying rack server shipping carton contents
- Installing hardware options
- Installing the server into the rack
- Installing the cable management arm
- Powering up and configuring the server
- Installing the operating system
- Registering the server
- Hardware options installation
- Expansion board options
- Memory options
- Server cabling
- Server software and configuration utilities
- Electrostatic discharge
- Troubleshooting
- Troubleshooting resources
- Pre-diagnostic steps
- Loose connections
- Service notifications
- Troubleshooting flowcharts
- POST error messages and beep codes
- Introduction to POST error messages
- Processor Reduced Power Mode Enabled in RBSU
- Processor Not Started (Processor Stalled)
- Processor Not Started (Stepping Does Not Match)
- Processor Not Started (Unsupported Processor Stepping)
- Processor Not Supported (Unsupported Core Speed)
- This system only supports 667 MHz Front Side Bus Speed Processors. One or more 800 MHz Front Side Bus Speed Processors have been initialized at 667 MHz. System Halted!
- Unsupported PCI Card Detected Remove PCI Card from Slot
- Unsupported Processor Configuration (Processor Required in Slot #1)
- WARNING - Mixed Feature Processors Were Detected
- WARNING - Mixed Stepping Processors were detected. System cannot proceed.
- WARNING - Resetting Corrupted CMOS
- WARNING - Resetting Corrupted NVRAM
- WARNING - Resetting Corrupted System Environment
- WARNING - Restoring Default Configurations as Requested
- Regulatory compliance notices
- Regulatory compliance identification numbers
- Federal Communications Commission notice
- Declaration of conformity for products marked with the FCC logo, United States only
- Modifications
- Cables
- Canadian notice (Avis Canadien)
- European Union regulatory notice
- Japanese notice
- BSMI notice
- Korean notice
- Laser compliance
- Battery replacement notice
- Taiwan battery recycling notice
- Power cord statement for Japan
- Server specifications
- Technical support
- Acronyms and abbreviations
- Index