HP ProLiant SL335s G7 Server - Manual (Page 28)

Hardware options installation 28
8. Close the processor socket retaining bracket and the processor retaining latch.
9. Remove the heatsink protective cover.
CAUTION: Heatsink screws should be tightened and loosened in alternating sequence. Do not
overtighten the screws as this can damage the system board, connectors, or screws. When using
a torque wrench, tighten the screws to .68 Nm --.90 Nm (6-8 in-lb.) of torque.
NOTE: Make sure the wedge on the heatsink faces away from the DIMMs.
10. Install the heatsink:
a. Position the heatsink on the processor backplate.
b. Tighten the first screw about three quarters in, and then tighten the second screw completely.