HP OmniBook 5500 Notebook PC - Manual (Page 9)

Using OmniBook Accessories
Installing and Removing Accessories
1-9
To install the floppy drive
1. If necessary, remove the current accessory module from the OmniBook.
2. Slide the floppy drive into the OmniBook until it clicks into place.
–or–
Connect the floppy drive to the OmniBook externally by pulling out the floppy
drive cable and connecting it to the parallel port on the left side of the
OmniBook.
Important The external floppy drive works only with the OmniBook’s parallel port. It does not
work with the parallel port on the docking system.
Parallel port