HP OmniBook 5500 Notebook PC - Manual (Page 11)

Using OmniBook Accessories
Installing and Removing Accessories
1-11
To install the CD-ROM drive
You install the CD-ROM drive in the center drive bay of the OmniBook. To use both
the CD-ROM drive and the floppy disk drive, connect the floppy disk drive to the
OmniBook’s parallel port (on the left side of the OmniBook).
1. Important
Save your work—you’ll be restarting the OmniBook.
2. If necessary, remove the current accessory module from the OmniBook.
3. Slide the CD-ROM drive into the OmniBook until it clicks into place.
4. Press the square Off button for 2 seconds, then press the blue On/Suspend
button to restart the OmniBook.
Off button