Removable media device options, Removing the removable media blanks – HP ProLiant ML370 G5 Server User Manual
Page 55
Hardware options installation 55
12.
For rack models, install the rack bezel.
13.
Install the access panel (on page
14.
Install hard drives ("
Installing a hot-plug hard drive
) or hard drive blanks, as needed.
15.
Do one of the following:
o
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
Removable media device options
The server supports the installation of a CD-ROM drive, USB tape drive, or optional diskette drive in the
removable media bay.
Removing the removable media blanks
1.
Power down the server (on page
2.
Unlock the tower bezel.
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
NOTE:
HP recommends that you move the CD-ROM drive out of the media cabling area for
ease of installation. It is not necessary to disconnect and remove the CD-ROM drive from the
server entirely.