Nilfisk-ALTO Captor 4300 - Manual (Page 24)

A-24 - FORM NO. 56041580 - Captor ™ 4300, 4800, 5400 / CR 1100, 1200, 1400
A-24 / ENGLISH
FIGURE 5
SIDE BROOM MAINTENANCE
The side broom(s) move dirt and debris away from walls or curbs and into the path of the main broom. Adjust the side broom so that the
bristles are contacting the À oor from the 10 O’clock (A) to the 3 O’clock (B) area shown in ¿ gure 5 when the broom is down and running.
To adjust the Side Broom...
1 The side broom(s) are adjusted simply by pressing and holding the Side Broom DOWN/ON Switch (N) or the Side Broom UP/OFF
Switch (Y) until the desired amount of bristles are contacting the À oor.
NOTE: The machine should be stored with the Side Broom(s) in the raised position. The Side Broom(s) should be replaced when the
bristles are worn to a length of 3 inches (7.62 cm) or they become ineffective.
To replace the Side Broom...
1 Raise the Side Broom(s).
2 Reach under the Side Broom and remove the large Thumb-Nut holding the side broom on and remove the broom and plastic disc.
3 Install the new broom and plastic disc by aligning the three alignment pins and pushing on. Re-install the Thumb-Nut and tighten.
TOP VIEW OF HOPPER