Nilfisk-ALTO Captor 4300 - Manual (Page 22)

A-22 - FORM NO. 56041580 - Captor ™ 4300, 4800, 5400 / CR 1100, 1200, 1400
A-22 / ENGLISH
MAINTENANCE SCHEDULE
Keep the machine in top condition by following the maintenance schedule closely. Maintenance intervals given are for average operating
conditions. Machines used in severe environments may require service more often.
MAINTENANCE ITEM PERFORM DAILY PERFORM WEEKLY
Perform the “After Use” maintenance steps X
Check parking brake X
Check engine oil X
*Clean main and side brooms X
Check ¿ lter indicator and lights (hyd & air) X
Check engine coolant level X
Check hydraulic oil level X
Drain / Check / Clean Tanks & Hoses X
Purge Detergent System (AXP/EDS only) X
MAINTENANCE ITEM 15 hrs. 30 hrs. 150 hrs. 300 hrs. 500 hrs. 1000 hrs.
*Rotate main broom X
Clean solution ¿ lter X
*Inspect/adjust brooms X
Check / Clean Hopper Dust Control Filter Using Method “A” X
*Inspect broom housing skirts X
*Inspect hopper seals X
Clean radiator and oil cooler X
Perform engine maintenance X
*Inspect and grease steering rack X
Check / Clean Hopper Dust Control Filter Using Method “B” X
Check / Clean Hopper Dust Control Filter Using Method “C” X
Change the hydraulic “charge” oil ¿ lter X
Change reservoir hydraulic oil and ¿ lter X
Flush the radiator X
Engine fuel ¿ lter(s) gas or propane X
*See the Mechanical Repair Service Manual for detailed maintenance information of systems listed. (Sweeping, Hopper, Steering, Dust
Control, Squeegee)
FIGURE 3
revised 11/07