HP LP3065c 30 inch LCD Monitor - Manual (Page 10)

3 Setting Up the Monitor
To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other
attached devices, then follow the instructions below.
NOTE Be sure the master power switch, located on the rear panel of the monitor, is in the off
position. The master power switch turns off all power to the monitor.
Installing the Monitor Pedestal Base
NOTE Do not install the pedestal if the monitor will be used on a wall, swing arm, or other
mounting fixture; instead see the section on Mounting the Monitor in this chapter.
1. Using both hands, position the monitor over the pedestal base.
CAUTION Do not touch the surface of the LCD panel. Pressure on the panel may cause
non-uniformity of color or disorientation of the liquid crystals. If this occurs the screen will
not recover to its normal condition.
2. Press down firmly on the monitor to lock the pedestal base in place. When the base locks, it will
make a clicking sound.
Figure 3-1 Inserting the Monitor into the Pedestal Base
4 Chapter 3 Setting Up the Monitor ENWW