HP OmniBook 4100 Notebook PC - Manual (Page 23)

Troubleshooting
7SPZMRK 4VSFPIQW [MXL 4PYK-R %GGIWWSVMIW
1-23
Solving Problems with Plug-In Accessories
If your OmniBook accessory doesn’t seem to work properly, find the symptom
below that matches your situation. Try the suggestions one at a time.
For information about the latest software drivers, go to the HP OmniBook website at
http://www.hp.com/omnibook.
This section separates problems into the following categories:
♦ Floppy disk drive problems.
♦ CD-ROM drive problems.
♦ LS-120 drive problems.
♦ DVD drive problems.
♦ Battery problems.
Floppy disk drive problems
If the floppy disk drive doesn’t work
•
Remove and reinsert the floppy disk.
•
If connected externally, check the floppy disk drive cable connection.
•
Try using an alternate connection (internal or external connection).
•
Check to see that the floppy disk drive configuration is correct in the BIOS Setup
utility. See the OmniBook Reference Guide for instructions on running the BIOS
Setup utility.
If the OmniBook doesn’t boot successfully from the floppy disk drive
•
If connected externally, check the floppy disk drive cable connection.
•
Try using an alternate connection (internal or external connection).
•
Run the BIOS Setup utility make sure that the floppy disk drive is the first boot
device. See the OmniBook Reference Guide for instructions on running the BIOS
Setup utility.