HP OmniBook 4100 Notebook PC - Manual (Page 13)

Using OmniBook Plug-In Modules
9WMRK XLI 07 HVMZI
1-13
Using the LS-120 drive
The LS-120 drive reads and writes to LS-120 disks (120 MB) and to conventional 3.5-
inch IBM-formatted disks (1.44 MB), which are the same size and shape. However,
the LS-120 drive reads and writes to LS-120 disks significantly faster than to
conventional disks. You cannot boot from an LS-120 drive.
This section describes how to
♦ Insert or eject a LS-120 disk.
♦ Eject a LS-120 disk manually.
To insert or eject a LS-120 diskette
' % 9 8 - 3 2 (S RSX MRWIVX SV VIQSZI E 07 HMWO [LMPI XLI 3QRM&SSO MW EGXMZIP] VIEHMRK SV
[VMXMRK HEXE 3XLIV[MWI XLI 3QRM&SSO GSYPH WXST VIWTSRHMRK ERH ]SY GSYPH PSWI
HEXE
1. Hold the LS-120 disk with its face up, then slide it into the disk drive slot until it
clicks into place.
2. To remove the LS-120 disk, press the eject button on the front of the drive as you
would with a floppy drive (the drive will take a moment to eject the disk).
–or–
If you’re using Windows 95, right-click the LS-120 drive in Windows Explorer or
My Computer and select Eject. This will not work in Windows NT 4.0.
To eject a LS-120 disk manually
' % 9 8 - 3 2 9WI XLI QERYEP HMWO INIGX TVSGIHYVI SRP] [LIR 3QRM&SSO TS[IV MW SJJ (S RSX XV]
XS JSVGMFP] VIQSZI E 07 HMWO JVSQ XLI HVMZI -J XLI HMWO HSIW RSX INIGX
MQQIHMEXIP] VITIEX XLI QERYEP HMWO INIGX TVSGIHYVI