HP Integrity NonStop J-Series - Manual (Page 90)

Figure 34 SET SESSION example 1
Internally, MXDM concatenates the Name and Value fields to form the SET command. Therefore,
you can specify the value alone in the value field and the rest of the command in the Name field,
as shown in the example. Alternatively, you can specify the type of the SET command in the Name
field and the rest of the command in the Value field. HP recommends that you use this approach.
Figure 35 (page 90) shows an example.
Figure 35 SET SESSION example 2
Using the Control Query Defaults tab
To add or modify a CQD configured for a data source:
1.
In the navigation tree pane, click Connectivity.
2. Complete the initial steps to create a data source until you see the following shown in
Figure 36 (page 90) .
Figure 36 Data source configuration
For information on creating a data source, see “Creating a data source” (page 85) or
“Updating a data source” (page 94) )
3. Click Control Query Defaults.
4. Click Add... or Modify...
5. In the CQD Name field, enter a new name or change the existing name.
6. In the Value field, enter a new CQD value, or change the current value.
90 Managing MXCS objects