HP Deskjet 3848 Color Inkjet Printer - Manual (Page 85)

Computer does not meet system requirements
If your computer does not have enough RAM or does not have a large amount of
free space on the hard drive, then the printer processing time will be longer.
1. Verify that the computer hard disk space, RAM, and processor speed meet the
system requirements.
For the system requirements, see the reference guide that came with the
printer.
2. Make space available on the hard drive by deleting unneeded files.
Printer is in ink-backup mode
The printer might print more slowly if it is in ink-backup mode .
To increase the print speed, use two print cartridges in the printer.
Best or Maximum dpi print mode is selected
The printer prints slower when Best or Maximum dpi is selected as the print quality.
To increase the printer speed, select a different print quality mode.
10.10 Error messages
Out of paper message
Follow the appropriate steps for the condition that exists.
If the In tray is loaded
1. Verify the following:
• A sufficient amount of paper is loaded in the paper tray (at least ten sheets).
• The In tray is not overly full.
• The paper stack is touching the back of the In tray.
2. Slide the paper guide so that it fits firmly against the edge of the paper.
If the In tray is empty
1. Load paper in the In tray.
2. Push the paper forward until it stops.
3. Slide the paper guide so that it fits firmly against the edge of the paper.
An error message appears while the Power light is flashing
Read the error message explaining the problem and its solution.
HP Deskjet 3840 series printer
85