HP Compaq S2021 20-inch Widescreen LCD Monitor - Manual (Page 26)

Icon Main Menu Options Sub-menu Options Description
Select language of the OSD from English,
Deutsch, Français, Español, Italiano,
Simplified Chinese, traditional Chinese and
Japanese.
Selects the input source for VGA and DVI.
(select models)
Resets monitor return to original setting.
Language
Input Select
Reset
Selects and displays important information
about the monitor
Identifying Monitor Conditions
Special messages appear on the monitor screen for the following monitor conditions:
●
Input Signal Out of Range — Indicates the monitor does not support the video card’s input signal
because its resolution or refresh rate are set higher than the monitor supports.
Change your video card settings to a lower resolution or refresh rate. Restart your computer for
the new settings to take effect.
●
Monitor Going to Sleep — Indicates the screen display is entering a sleep mode. The speakers
(select models) are turned off in sleep mode.
● Check Video Cable — Indicates a video input cable is not properly connected to the computer or
monitor.
●
OSD Lock — The OSD can be enabled or disabled by pressing and holding the Menu button
on the front bezel for 10 seconds. If the OSD is locked, the warning message OSD Lock-out appears
for 3 seconds.
If the OSD is locked, press and hold the Menu button for 10 seconds to unlock the OSD.
If the OSD is unlocked, press and hold the Menu button for 10 seconds to lock the OSD.
● No Input Signal — Indicates the monitor is not receiving a video signal from the computer on the
monitor video input connector. Check to see if the computer or input signal source is off or in the
power-saver mode.
● Auto Adjustment in Progress — Indicates the auto adjustment function is active. See “Adjusting
Screen Quality” in this chapter.
20 Chapter 4 Operating the Monitor ENWW
● Power Lock — The power can be enabled or disabled by holding “OK”,”+” and pressing “Power”
button. When the Power is locked/unlocked, the warning message of power Lock/unlock appears for
3 seconds.
If the “Power” key is locked, hold “OK”,”+” and press “Power” button to unlock the “power” key.
If the “Power” key is unlocked, hold “OK”,”+” and press “Power” button to lock the “power” key.
Miscellaneous
Information