Photos do not print correctly – HP Deskjet 5943 Photo Printer User Manual
Page 63
If you receive the ink-backup mode message and two print cartridges are installed in
the printer, verify that the plastic tape has been removed from each print cartridge.
When the protective piece of plastic tape covers the print cartridge contacts, the
printer cannot detect that the print cartridge is installed.
1 Remove plastic tape
Print cartridge is in the wrong slot message
If you receive this error message, the print cartridge is installed in the wrong side of
the print cartridge cradle.
Always install the tri-color print cartridge in the left print cartridge cradle compartment.
Install the black or photo print cartridge in the right print cartridge cradle compartment.
Note
To easily identify the correct side of the cradle in which to install the
print cartridge, match the symbol on the print cartridge with the symbol above
the print cartridge cradle.
Photos do not print correctly
Check the paper tray
1.
Verify that the photo paper is placed in the In tray with the side to be printed on
facing down.
Verify that the photo paper is flat.
2.
Slide the paper forward until it stops.
3.
Slide the paper guide firmly against the edge of the paper.
Do not press the guide so firmly against the paper that the paper bends or curls.
Check the printer settings
1.
Open the
2.
In the Page Attributes pane, verify the following settings:
–
Paper Size: The appropriate paper size
–
Orientation: The appropriate orientation
3.
Open the
dialog box.
4.
In the Paper Type/Quality pane, verify the following settings:
–
Paper Type: The appropriate photo paper type
–
Quality: Best or Maximum dpi
5.
Use the
for photo enhancement.
User's guide
61