Aquatic LuxeAir Series - Manual (Page 9)

aquatic Industries, Inc. 9
1. To avoid obstructions during installation, make sure water lines, spout pipes and valve plumbing do not project into alcove.
2. Ledger Strip: Fasten a 1” x 3” (25mm x 75 mm) ledger strip along rear for alcove and along both sides in corner installations
at Dimension Lh. (see Diagram 3A)
3. Place three or four mounds of mortar away from drain hole in a line or square, approximately twice as high as the cavity
under the tub bottom.
4. Place tub into alcove with front skirt firmly on floor and depress mortar mounds. Make certain that back ledge of tub rests
firmly on ledger strip. (see Diagram 3A)
5. See and follow Sealing & Finishing Diagram 3B.
These models are offered with removable panels. It provides a
flush-to-wall installation (sheet rock overlaps skirt while still providing
access). The skirt features a decorative removable panel enabling
easy access to motor, pump, blower and electrical hookups. clips
enable simple and quick removal of skirt access panel.
important: Before installation of the panel, fill the unit, test the whirlpool
system for proper operation and check for leaks, then drain.
iNSTALLATiON iNSTruCTiONS
3A
Framing
Dry wall
4A
Right Side Edge
Clips
(back of panel)
Panel
Left Side Edge
Integrally Skirted Acrylic Whirlpool
3B
iNSTALLATiON PrOCEdurES FOr iNTEgrALLy SKirTEd mOdELS:
rEmOVABLE SKirT PANELS FOr iNTEgrALLy SKirTEd mOdELS: