HP Integrity NonStop H-Series - Manual (Page 26)

6. If you entered y to the Do you want to enable the SQL/MX persistence (n or
[y]):
question, the installation continues and you are prompted to enter the schema details.
Enter the catalog name to be used :
This is the catalog where you want to create the schema.
Enter the schema name to be used :
This is the schema to be created for the specified catalog.
Do you want to create the catalog and schema?, Enter (y or [n]):
Type y and press Enter if you want to create the new catalog and schema. If you enter y, you
are prompted to enter the location for the catalog.
Enter the location for catalog. (e.g. $SAS1) :
This is the volume where the catalog gets created.
Enter the location for ACTIVEMQ_MSGS table (e.g. $SAS1) :
This is the volume where ACTIVEMQ_MSGS table gets created.
Enter the location for ACTIVEMQ_ACKS table [$SAS1] :
This is the volume where ACTIVEMQ_ACKS table gets created.
Enter the location for BLOB_DATA table [$SAS1] :
This is the volume where BLOB_DATA table gets created.
After the prompts are entered, if the schema creation is successful, the following message is
displayed:
Created schema in SQL/MX for NSMQ
Installation complete
If the schema creation fails, the following message is displayed:
There was an error while creating NSMQ schema.
Please check /tmp/.log for more details.
Do you want to try again?(n or [y]):
If you type y, you will be prompted to re-enter the schema details.
If you type n, the installation will exit.
Customizing NSMQ installation
You can customize NSMQ installation according to your requirements. The following list provides
the various methods of customizing your NSMQ installation:
•
“Using 64-bit NSJ7” (page 26)
•
“Configuring the JDBC connection pool-size” (page 27)
•
“Configuring the JRE heap values” (page 27)
•
“Configuring SSL” (page 44)
Using 64-bit NSJ7
Install NSMQ and perform the following steps after adding brokers to a cluster, but before starting
the cluster or brokers:
1. Open a TACL prompt.
2. Use the PATHCOM program to modify the NSMQ brokers as follows:
a.
Type PATHCOM $ and press Enter.
b. Change the Java program of the brokers using the ALTER SERVER command.
For example, if you have added two brokers, BRK1 and BRK2, enter the following
commands:
26 Installation and configuration