HP NC112T PCI Express Gigabit Server Adapter - Manual (Page 11)

Specifications 11
Specifications
HP NC112T PCI Express Gigabit Server Adapter
specifications
Specification Value
Network Controller Chipsets Intel® 82574L
Bus Type
x1 PCI Express v1.1 (2.5 GTps)
Bus Width One lane (x1)
On-board Memory 32 KB
Data Transfer Method Bus Master DMA
Boot ROM Support Yes
Management Capabilities WOL, PXE 2.2, ACPI 1.0 (Note: WOL and PXE are set to the default of off)
Power Requirement 575 mA @ 3.3 VDC max
Data Transmission Rate 10 Full/10 Half, 100 Full/100 Half, 1000 Full
Standards Supported IEEE 802.3u, IEEE 802.3x (flow control), IEEE 802.3ad (link aggregation), IEEE
802.1p (QoS), IEEE 802.1q (VLAN tagging), IEEE802.3z, IEEE802.3ap,
IEEE802.3ae
Dimensions 11.93 cm x 5.58 cm [4.7 in x 2.2 in (L x W)] (without bracket)
Connector and Distances 10BASE-T: Category 3, 4, or 5 UTP 100 M (328 ft)
100BASE-TX: CAT5 UTP 100 M (328 ft)
1000BASE-TX: CAT5 UTP 100 M (328 ft)
Interrupts Supported Automatically configured
Temperature Range Operating: 0°C to 55°C (32°F to 131°F)
Storage: -40°C to 85°C (-40°F to 185°F)
Relative Humidity (non-
condensing) Operating: 10% to 95%
Storage: -5% to 95%
Safety Compliance UL Mark (US and Canada)
CE Mark
EN60950
RoHS (European Union)
UTP cable specifications
The NC112T adapter can use existing UTP CAT5 (or better) cable to deliver Gigabit Ethernet over
copper, according to the IEEE 802.3ab specifications. For new installations, CAT5e (enhanced CAT5)
cable is recommended.