HP 18-5021 All-in-One Desktop PC - Manual (Page 27)

Declaration of conformity for products marked with the FCC logo (United States only)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
For questions regarding the product, contact:
Hewlett-Packard Company P.O. Box 692000, Mail Stop 530113 Houston, Texas 77269-2000
For questions regarding this FCC declaration, contact:
Hewlett-Packard Company P.O. Box 692000, Mail Stop 510101 Houston, Texas 77269-2000
Or, call (281) 514-3333.
To identify this product, refer to the part, series, or model number found on the product.
Products with wireless LAN devices
This product may be equipped with a wireless LAN device. This device must not be co-located or
operating in conjunction with any other antenna or transmitter.
WARNING! Exposure to Radio Frequency Radiation The radiated output power of this device is
below the FCC radio frequency exposure limits. Nevertheless, the device should be used in such a
manner that the potential for human contact is minimized during normal operation.
During normal operation: To avoid the possibility of exceeding the FCC radio frequency exposure
limits, human proximity to the antennae should not be less than 20 cm (8 inches). To identify the
location of the wireless antennae, refer to the documentation included with the computer.
CAUTION: When using IEEE 802.11a wireless LAN, this product is restricted to indoor use, due to
its operation in the 5.15- to 5.25-GHz frequency range. The FCC requires this product to be used
indoors for the frequency range of 5.15 GHz to 5.25 GHz to reduce the potential for harmful
interference to cochannel mobile satellite systems. High-power radar is allocated as the primary user
of the 5.25- to 5.35-GHz and 5.65- to 5.85-GHz bands. These radar stations can cause interference
with and/or damage to this device.
Australia telecom statement
The computer must be connected to the Telecommunication Network through a line cord that meets
the requirements of AS/CA S008.
WARNING! Modems without integral RJ11 connector that are shipped with this computer should not
be installed in any other device.
This equipment incorporates a radio transmitting and receiving device. In normal use, a separation
distance of 20 cm ensures that radio frequency exposure levels comply with the Australian and New
Zealand Standards.
Electromagnetic compatibility notices 19