Laser compliance, Modem notices, Telecommunications device approvals – HP 18-5021 All-in-One Desktop PC User Manual
Page 18: Laser compliance modem notices
Additional information on the ENERGY STAR program and its environmental benefits are available
on the EPA ENERGY STAR Web site at
Laser compliance
WARNING!
Use of controls or adjustments, or performance of procedures other than those
specified in the laser product installation guide, may result in hazardous radiation exposure. To
reduce the risk of exposure to hazardous radiation:
●
Do not try to open the module enclosure. There are no user-serviceable components inside.
●
Do not operate controls, make adjustments, or perform procedures to the laser device other than
those specified in the laser product installation guide.
●
Allow only authorized service providers to repair the unit.
This product may be provided with an optical storage device (for example, a CD or DVD drive) and/or
a fiber optic transceiver. Each of these devices that contain a laser is classified as a Class 1 Laser
Product in accordance with IEC/EN 60825-1 and meets the requirements for safety of that standard.
Each laser product complies with US FDA regulations of 21 CFR 1040.10 and 1040.11 or complies
with those regulations except for deviations pursuant to Laser Notice No. 50 dated June 24, 2007.
Modem notices
WARNING!
To reduce the risk of fire, electric shock, and injury to persons when using this device,
always follow basic safety precautions, including the following:
●
Do not use this product near water—for example, near a bathtub, wash bowl, kitchen sink or
laundry tub, in a wet basement, or near a swimming pool.
●
Avoid using this product during an electrical storm. There is a remote risk of electric shock from
lightning.
●
Do not use this product to report a gas leak while in the vicinity of the leak.
●
Always disconnect the modem cable before opening the equipment enclosure or touching an
uninsulated modem cable, jack, or internal component.
●
If this product was not provided with a telephone line cord, use only No. 26 AWG or larger
telecommunication line cord.
●
Do not plug a modem or telephone cable into the RJ-45 (network) jack.
SAVE THESE INSTRUCTIONS.
Telecommunications device approvals
The telecommunications device in the computer is approved for connection to the telephone network
in the countries and regions whose approval markings are indicated on the product label located on
the bottom of the computer or on the modem.
Refer to the user guide included with the product to ensure that the product is configured for the
country or region in which the product is located. Selecting a country or region other than the one in
which it is located may cause the modem to be configured in a way that violates the
telecommunication regulations/laws of that country or region. In addition, the modem may not function
properly if the correct country or region selection is not made. If, when you select a country or region,
a message appears that states that the country or region is not supported, this means that the
modem has not been approved for use in this country or region and thus should not be used.
10 Chapter 1 Regulatory notices for notebook computers