HP LD5535 55-inch LED Digital Signage Display - Manual (Page 37)

Ethernet Network
To use Network (Ethernet) communication:
1. Under Communication Select, select Network.
2. Click OK to complete.
RS-232-C Serial Communication
To use RS-232-C serial communication:
1. Under Communication Select, select Serial.
Adjust the serial communication settings to fit your environment.
Item Description
Port Communication port (COM1 - COM9), Default: COM1
Baudrate Communication speed (2400 - 115200), Default: 9600
Data Communication data (Data5 - Data8), Default: Data8
Parity Parity check (even, odd, none), Default: none
Stop The number of stop bits (0 - 1), Default: 1 bit
Flow Control Data flow (Xon/Xoff, hardware, none), Default: none
2. Click OK to complete.
Connect
Connect is used to reconnect HP Network Sign Manager to the network manually when the display
is disconnected.
The following describes how to reconnect a specified display to the network.
1. Select a display or display group to reconnect.
2. Click Connect.
NOTE: This function does not support a display connected with serial communication.
Toolbar 31