HP Compaq 515 Notebook-PC - Manual (Page 17)

4. In the Device Configurations window, select RAID to the right of SATA Device Mode. Click
Yes when the message displays: “Changing this setting may require reinstallation of your operating
system. Are you sure you want to proceed?”
NOTE: The HDD image supplied with your notebook PC contains drivers that allow you to switch
between AHCI and RAID modes without reinstalling the operating system. If you use a different
HDD image, you may need to reinstall the operating system.
5. Select File > Save Changes and Exit. Then, click Yes to save the changes. If you do not want to
apply your changes, select Ignore Changes and Exit.
CAUTION: Do NOT turn the computer power off while the ROM is saving the f10 Computer Setup
changes as the Complementary Metal Oxide Semiconductor (CMOS) could become corrupted.
Only turn the computer off after exiting the f10 Setup screen.
6. After the operating system boots, you can begin the RAID migration procedure.
Enable RAID through the system BIOS (f10) 13