HP Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem - Manual (Page 36)

Installation 36
Because Virtual Connect communicates with other components through the Onboard Administrator,
special considerations are required when using EBIPA with Virtual Connect Ethernet modules:
• The Onboard Administrator must be on the same IP subnet as all Virtual Connect modules.
• The Onboard Administrator IP address must be set properly before changing the IP addresses of the
Virtual Connect modules.
Installing a VC-Enet module
1. Remove the interconnect blank.
NOTE: HP Virtual Connect works optimally in enclosures configured with HP Virtual Connect
interconnect modules only.
2. Prepare the VC-Enet module for installation (HP 1/10Gb VC-Enet Module shown).