Connecting the network cable – HP Ethernet 10Gb 2-port 530FLR-SFP Adapter User Manual
Page 9
Installing an adapter 9
1.
Using a correctly sized slotted screwdriver, carefully remove the two board lock screws located at the
top and bottom of the connector.
2.
Remove the standard profile bracket and place the low profile bracket over the connector. Be careful
not to damage the connector or bind the low profile bracket to the connector.
Connecting the network cable
The HP Ethernet 10Gb 2-port 530SFP+ has two SFP+ ports. These ports support either of the following:
•
Direct Attached Copper (DAC) cables
•
Optical Modules to be used with fiber optic cables
See Cable specifications (on page
) for the maximum cable length supported.
To connect the HP Ethernet 10Gb 2-port 530SFP+ to the network, complete the following steps:
1.
Orient the SFP+ optical module or DAC cable so that the Gold Fingers on the edge of the circuit board
is located closest to the option card circuit board.
2.
Install the SFP+ optical module or DAC cable all the way into the SFP+ socket until it clicks into place
and is securely latched.
3.
If an optical module is used, remove the protective cover and connect the fiber optic cable.