HP XP P9500 Storage - Manual (Page 47)

Table 19 RAID Manager Errors Related to Manual Migration Plans (continued)
Required Action Message Error Code
(SSB2)
Release the IBM Concurrent Copy pair, and then
migrate the volume. The migration target volume is a primary volume
of IBM Concurrent Copy. 2366
Change the Continuous Access Synchronous pair
status from COPY to PAIR or PSUS, or delete the The volume is being used as the primary volume
of the Continuous Access Synchronous pair. The
pair is in the COPY status. 2368
Continuous Access Synchronous pair, and then
migrate the volume.
Change the Continuous Access Synchronous pair
status from COPY to PAIR or PSUS, or delete the The volume is being used as the secondary volume
of the Continuous Access Synchronous pair. The
pair is in the COPY status. 2369
Continuous Access Synchronous pair, and then
migrate the volume.
Migrate the volume after the Business Copy pair
is changed to SPLIT status. The migration source volume is the primary volume
of a Business Copy pair which is in the SP-PEND
status. 236A
Migrate the volume after the Business Copy pair
is changed to SPLIT status. The migration source volume is the secondary
volume of a Business Copy pair which is in the
SP-PEND status. 236B
Install the volume or select another source volume. The migration source volume is not installed. 2370
Perform the following actions for each cause: The migration source volume corresponds to either
of the following causes: 2371
1) Recover the blocked volume, and then migrate
the volume.
1) The volume is blocked.
2) None. A system disk cannot be used as a
source volume. 2) The volume is the system disk.
Migrate the volume after formatting is completed. The migration source volume is being formatted. 2372
None. A command device cannot be used as a
source volume. The migration source volume is a command device. 2373
Release the Continuous Access Synchronous pair,
and then migrate the volume. The migration source volume is an external volume
specified as a primary volume of Continuous
Access Synchronous. 237C
Install the volume or select another target volume. The migration target volume is not installed. 2380
Perform the following actions for each cause: The migration target volume corresponds to either
of the following causes: 2381
1) Recover the blocked volume, and then migrate
the volume.
1) The volume is blocked.
2) None. A system disk cannot be used as a target
volume. 2) The volume is the system disk.
Migrate the volume after formatting is completed. The migration target volume is being formatted. 2382
None. A command device cannot be used as a
source volume. The migration target volume is a command device. 2383
Release the setting of Cache Residency, and then
migrate the volume. Cache Residency is set on the migration source
volume. 2389
Release the setting of Cache Residency, and then
migrate the volume. Cache Residency is set on the migration target
volume. 238A
None. LUSE volumes cannot be specified as source
volumes or target volumes. The migration source volume and the migration
target volume is specified as LUSE volumes. 238B
Cancel the reservation by Business Copy, and then
migrate the volume. The migration target volume is a reserved volume
of Business Copy. 238C
Troubleshooting when using RAID Manager 47