HP Compaq 320 Notebook-PC - Manual (Page 116)

Setting a DriveLock password
To set a DriveLock password in Computer Setup, follow these steps:
1. Turn on the computer, and then press esc while the “Press the ESC key for Startup Menu”
message is displayed at the bottom of the screen.
2. Press f10 to enter BIOS Setup.
3. Use a pointing device or the arrow keys to select Security > DriveLock Password, and then
press
enter .
4. Use a pointing device to click the hard drive you want to protect.
– or –
Use the arrow keys to select the hard drive you want to protect, and then press enter .
5. Read the warning. To continue, select YES.
6. Type your master password in the New password and Verify new password fields, and then
press
enter .
7. Type your user password in the New password and Verify new password fields, and then
press
enter .
8. To confirm DriveLock protection on the drive you have selected, type DriveLock in the
confirmation field, and then press
enter .
NOTE: The DriveLock confirmation is case sensitive.
9. To save your changes and exit Computer Setup, click the Save icon in the lower-left corner of
the screen, and then follow the on-screen instructions.
– or –
Use the arrow keys to select File > Save Changes and Exit, and then press enter .
Your changes go into effect when the computer restarts.
Entering a DriveLock password
Be sure that the hard drive is inserted into the computer (not into an optional docking device or
external MultiBay).
At the DriveLock Password prompt, type your user or master password (using the same kind of
keys you used to set the password), and then press
enter .
After two incorrect attempts to enter the password, you must shut down the computer and try again.
Changing a DriveLock password
To change a DriveLock password in Computer Setup, follow these steps:
1. Turn on the computer, and then press esc while the “Press the ESC key for Startup Menu”
message is displayed at the bottom of the screen.
2. Press f10 to enter BIOS Setup.
104 Chapter 10 Security