HP TouchSmart 9300 Elite All-in-One PC - Manual (Page 14)

2 Reinstalling the stand on your
HP TouchSmart PC
You may decide to convert your HP TouchSmart PC from a wall-mounted unit back to a desktop unit.
You will need to install the computer stand back on to your HP TouchSmart PC. The VESA adapter plate
must be replaced on the bottom of the computer stand, in order to properly support the computer.
What you need
● A Phillips screwdriver and flathead screwdriver (magnetic-tipped recommended)
● A stable flat surface covered with a soft, clean cloth (such as a large towel) to protect the
computer when you place it face down.
● Another person (it might require two people to lift and move the computer)
● Antistatic wrist strap and conductive foam pad to stand on while working on the computer
(recommended)
Safety information
This product has not been evaluated for connection to an “IT” power system (an AC distribution system
with no direct connection to the earth, according to IEC 60950).
WARNING! Please read “Additional Safety Information” in the Limited Warranty and Support
Guide before installing and connecting your system to the electrical power system.
WARNING! The computer is heavy. Take proper precautions when lifting or moving your computer.
WARNING! Always disconnect the HP TouchSmart PC from the power source before removing the
computer stand. Failure to do so before you perform any procedures can result in personal injury or
equipment damage.
WARNING! Avoid touching sharp edges inside the computer.
10 Chapter 2 Reinstalling the stand on your HP TouchSmart PC Wall-Mounting your HP TouchSmart