LG CF3D - Manual (Page 14)

Installing and Composition
14
• This projector has a Kensington Security System Connector on the back or side panel. Connect the Kensington Security
System cable as below.
• For the detailed installation and use of the Kensington Security System, refer to the user’s guide included with the
Kensington Security System set. And for further information, contact http://www.kensington.com, the internet homepage
of the Kensington company that deals with expensive electronic equipment such as notebook PCs or projectors.
• The Kensington Security System is an optional item.
Kensington Security System
Turning on the Projector
1. Make sure the power cord is connected correctly.
2. Press the POWER button. The operation indicator will blink green while the projector is warming up.
• Power on time is long because of the characteristics of 3D Projector.
• Press the
INPUT button to select the input signal you want.
• There will be short sound when the projector is being turned on.
• Check if the lens cap is open before turning on the power.
Turning off the Projector
1. Press the POWER button.
2. The unit will turn off when you press the POWER button a second time. The operation indicator LED will
blink blue for 90 seconds while the bulb cools. Do not disconnect the projector while the LED (fan) turns off.
When the indicator becomes solid blue, you may remove the power cord if needed (Refer to page 10).
i Power off?
Please press Power key again.