LG HX350T - Manual (Page 23)

23
Operating the Projector
RGB Config. Function
1 . Press the STILL button on the remote control.
* You can freeze the moving image.
2. To exit Still, press any button.
* The STILL function will release automatically after approximately 10 minutes.
Using the Still Function
< Moving Image > < Still Image >
RGB Config.
Auto Config.
Position
Resolution ꔃ
Size
Phase
Reset
ꔐ 1024 x 768
1280 x 768
1360 x 768
ꔂMove ꕉPrev.
Press the AUTO button of the remote control.
• If you execute screen adjustment for a video from PC graphic signal, optimal state
may not be found. Execute the Auto Config. function for a still image.
• You can also use this function through the MENU button.
Auto Configure Function
* This function assures you of getting the best video quality by automatically adjusting the horizontal size and
synchronization of the image.
* Auto Tracking function works in RGB PC input only.
Auto config.
1 . Press the MENU button. Then, move to SCREEN with the ∧, ∨, ＜, ＞
buttons and press the ◉OK button.
2 . Press the ∧, ∨ buttons to move RGB Config. and press the ◉OK but-
ton.
3 . Move to a desired item with the ∧, ∨ buttons and then press the ＞
button.
4 . Press the ∧, ∨, ＜, ＞ button to adjust the screen condition as you
want and then press the ◉OK button.
• Resolution can be chosen between 768 resolution (1024x768/1280x768/1360x768, 60Hz).
• Press the
BACK button to exit the menu screen.