Advantech AIMB-256 - Manual (Page 29)

23 AIMB-256 User Manual
Chapter 1
P
roduction
Introduction
1.8.2 Amplifier Connector (AMPJ1) (Optional)
1.8.3 ATX Power Connector (ATXPWR1)
This connector is for an ATX Micro-Fit power supply. The plugs from the power sup-
ply are designed to fit these connectors in only one orientation. Find the proper orien-
tation and push down firmly until the connectors mate completely.
Important notes on the Motherboard Power Requirements
Note! ! Make sure that your ATX 12 V power supply can provide 8A on the
+12 V lead and at least 1A on the +5-volt standby lead (+5 VSB).
The minimum recommended wattage is 230 W, or 300 W for a fully
configured system. The system can become unstable and might
experience difficulty powering up if the power supply is inadequate.
! You must install a PSU with a higher power rating if you intend to
install additional devices.