Before you begin, Overview, Table 1: overview – Bosch HDI7052U User Manual
Page 7: Tools and parts needed, Installation
English 4
Before You Begin
Overview
Proceed to the sections that follow for step-by-step instructions.
Tools and Parts Needed
•
Range Power Supply Cord Kit (240V -30 Amp)
Note: Not necessary for Canadian installations; Canadian units are shipped
with the power cord already installed.
•
Measuring Tape
•
Phillips Head Screwdriver
•
1-1/4” (31.8 mm) Wrench
•
Pencil
•
T-20 Torx Screwdriver
•
Screws (2) and Anchors (2) for Anti-Tip Bracket (Style will vary depending on
mounting surface)
•
Level
•
Drill and Drill Bit
•
Soapy Water
•
Pipe Wrench
•
Teflon Tape
•
Channel Lock Pliers
•
Gas Leak Test Solution
•
Gas Supply Line
•
Gas Shut Off Valve
•
Safety Gloves and Goggles
•
Tape (Optional)
•
Cloth or Cardboard (Optional - to Protect Floor)
Additional Parts Needed For
Hard Wire Installations
•
Flexible Conduit
•
Torque Wrench
•
Note: Power Supply Cord Kit Not Necessary For Hard Wire Installations
Installation
Table 1: Overview
Step
Task
1.
2.
3.
Install Backwall Trim (Optional)
(Optional)
4.
5.
6.
7.